$ 1,301.00
(Ex GST)

More Information

• 6 km (19,000ft)
• 0.5mtr dead Zone
• Selectable Cable Impedance
• Warble Tone Generator
• Rapid Fault Location
• Large 128x64 LCD with Backlight
• Scratch Resistant Display
• Environmental Protection IP54
• CE Approved
• 3yrs Manufacturers Warranty
• 60 Hours Battery Life
• Soft bag & Test Leads
• Easy to Use

The TX2003, 6k (19,000ft) range Time Domain Reflectometer weighing only 350 grams (13oz) fits neatly into the hand. With its 128x64 pixel backlight, scratch resistant display, provides accurate and easy to read fault locations on metallic cables. With a 3 nano second pulse, rise time “near end” cable faults can be clearly identified without the need to surpress the transmitted pulse. Housed in a rugged IP54 rated ABS enclosure, the TX2003 is suitable for outside use.

Using pre determined gain and pulse widths for each range setting and with only 4 control buttons, all major operating and setting parameters can be easily accessed. A 6km cable run can be scanned in seconds, allowing the operator a view of the cable run, yet arriving quickly to the fault. By using the TX2003 scan lock facility, the cable can be continually scanned or the trace held for closer analysis. To enable the TX2003 to test all metallic cables, four user selectable output impedances are provided 25, 50, 75 & 100 ohms.

Faulty cables may be traced using the TX2003 warble tone feature, an oscilating tone is injected into the suspect power or transmission line and by using a commercially available tone tracing probe, the suspect line can be identified.

Ranges meters 7, 15, 30, 60, 120, 250, 500, 1km, 2km, 3km, 6km
Range Selection Manual range control
Accuracy 1% of selected range*
Resolution Approx 1% of range
Sensitivity Min 3 pixel return at 4km on 0,6mm Æ , PE , TP
Velocity Factor Adjustable from 1% to 99%
Output Pulse 5 volts peak to peak. Into open circuit
Output Impedance Selectable 25, 50, 75 & 100 ohms
Output pulse Width 3 ns to 3 ms, Automatic with range
Scan Rate 2 scans / second or scan held (not on 3km/6km range)
Tone Generator 810 - 1100Hz
Battery Life 60 hours continuous scanning
Power Supply 6 volts 4 x 1.5 AA Alkaline cells
Power Down Selectable 1, 2, 3, 5 minutes or disabled
Back Lit Display 128 x 64 pixel
Voltage Detection 250 volts AC
Operating Temp -10º / 50ºC
Storage Temp -20º / 70ºC
Dimensions 165 x 90 x 37 (6.5 x 3.5 x 1.5 ins)
Weight 350 gms (12oz)
Safety IEC 61010-1
Water/Dust Proof IP54